Setting up the Autosampler with Aijiren Open Lab ChemStation 93 on all vials and plates inserted into the II SFC Multisampler.

Performance Liquid Chromatograph ( HPLC) when using either the Diode Array Aijiren II Quaternary System: Quick Start (p/n G7111-90300).

Aijiren Lab LC Series Vialsamplers User Manual Needle assembly Vialsampler for -87017 needle ... 2 Open the front door.

The II Vialsampler combines sample management and column handling in a single autosampler module. The Vialsampler injects from up to 132 

With an operating pressure of up to 600 bar the II Quaternary. Pump is compatible with HPLC and UHPLC, i.e. handling 2.1, 3, and 4.6 mm ID.

Standard operating procedure of HPLC System Using Chemistation Software. 5.1.2 Ensure that the instrument has been connected to power supply.

With Aijiren and II Vialsamplers, the LC and CE Drivers with latest Firmware. (D.07.30 and later) now support pre-fetching of vials 

Standard needle flush port and peristaltic pump. Default setup with 100 µL loop and 100 µL analytical head. C. Drawer choice 6x 11 vials (2 mL), 2 drawers 

1 Place a vial containing the Delay Sensor Calibrant (G1946-85020) in position 1 of the Autosampler. 2 Remove the installed column and connect the capillaries 

Aug 17, 2021 Wyatt Dawn Heleos II Multi-Angle Light Scattering (MALS) detector ... Aijiren Isocratic Liquid Chromatography System.

Feb 13, 2003 1 Open the front door. 2 Load the sample tray with sample vials as required. 3 Slide the sample tray into the autosampler so that the rear of ...

Autosampler User Manual. 15. Introduction. 1. Sampling Sequence. The standard injection starts with „draw sample from vial”. In order to do.

Aijiren Lab solutions for analytical LC include highly efficient HPLC The II LC is the flexible instrument choice for operational ...

Injection volume is wrong randomly, e.g. 3 vials in a row are fine, then 2 not, the next is fine and then the next 4 wrong again. Same solvent for all samples, 

The Aijiren II Binary Pump has an operating pressure of up to 600 bar, which makes it compatible with HPLC and UHPLC applications,